Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
PCL comand for group calling in for cycle
Hello I'm trying to create a pcl to run the same commands in more groups using a for cycle. I created: Integer NumTotSection = 10 Integer SectionCounter STRING Name_Group[512](10) Name_Group(1)= "Alfa" /* so on ... Name_Group(10)= "Omega" /* and the for command FOR (SectionCounter = 1 TO...- Gaetan82
- Thread
- Replies: 2
- Forum: MSC.Software: Patran
-
How become PM: which certificate ?
Good Morning I'm an aerospace engineer with 2 years of experience and i'd like to study to become a PM; in my company, the managment is starting to assign me task "hard" so i thought to take a certificate in PM that can help me in my job and ( why not) give me future best opportunity. I'd like...- Gaetan82
- Thread
- Replies: 1
- Forum: Engineering project management general discussion
-
SOL 106 - How to understand convergence
Good Morning, I have a question: during a run 106 ( non linear static) a way to check if the run in going on is to open f06 and check the % of load applied: (like in this example = 30%) $$$$ 0 N O N - L I N E A R I T E R A T I O N M O D U L E O U T P U T... -
Epsilon in .f06 file - big value
Hi, i have a problem when trying to run a model in Nastran ( Sol 101) and hope that someone can help me: the epsilon value that i read in the .f06 file is about 1.70E-4; now, i know that this value is big and that, normally, a good value for epsilon is 10E-9 or smaller. I know also that this... -
How can i model the constraints of a spring ??
hi everyone.... i need help... i must model the behavior of a spring landing gear under a load acting on its tip ( i have already meshed the catia file using quad4 element)but stress are very high..i think that can be an error in my model constraint ....this spring infact has a pin and a bracket...
