Hi,
I would like to start business designing and building checking fixtures.
I was searching the internet, but I can't find an example of a checking fixture that I could study. For example GrabCad has a few of them, but there are no GD&T requirements that the design is based on.
If there is...
Hi,
can anyone help me with defining the force that is needed for shearing of sheet steel (st.37) with 2 rotating blades? The principle can be seen on this video: https://www.youtube.com/watch?v=da99re5O0Rc.
I need to define the force for penetration (blades going down) and for rotation of the...
Hi
I was wondering if this sensor could be used also to measure bending deformation. In the data-sheet no direction of loading is specified.
Can it be bend in both directions or only into the tensile direction?
Is this calculation correct:
Hi
I would like to have angular positioning of a lever with a Hirth couplung. Is it posible to design a couplung with one side of the tooth perpendicular (0° angle) and the other side normal (30°)? How difficult is to maschine such piece.
The problem:
I would like to have the rotation of the...
Hi
I just instaled the new version of SW 2012. Before I used 2010 and I was always constructing with bolts and nuts that I saved (as copy) in a special folder of the particular assembly. When I open this assembly with the new version, SW automaticly changes the bolts and nuts with the ones from...
Hi!
I was wondering if anyone here could help me.
I'm trying to find a way to change the color of the parts with the same material at once. Or maybe just to highlight them.
I would like to see which parts have which material specified. When I try to change the color of a material, it changes...
Hi,
can someone help me? I'm looking for the maximum protection of an aluminium plate (EN- AW 5083, 600x300x15) against wear like scratches, that appear for example when a person slides over the plate with some stones on his shoes.
Can the upper surface of the plate be protected with some kind...
Hi :)
I need to fasten a force sensor to an aluminium plate of 20mm thickness. The manufacturer of the sensor provides that it should be fastened with two bolts M12 12.9 with a torque of 130Nm onto a plate made of stainless steel (20mm). Because of the weight I can only use an aluminium plate...
Hi.
Does anyone have any suggestions how to simulate the force produced by a mass of 2,5 kg (max) falling from a hight of 20cm (max) into someones hands. We want to make some measurements in which we want to be able to change the amplitude of the force. The measurements would be held for 30...
