Dear all,
Please clarify the following doubts
For automated Ultrasonic testing,Demonstration requirement for ASME pressure vessel
Demonstration shall be documented as per ASME Sec V Appendix - VIII (scanner block) or AS per ASME sec V Appendix-IX.
PCS (ToFD) is essential variable or not...
Dear Sirs,
I have a doubt because When welding Pipe Stainless Steel 304L use the filler rod 308-L.
But in this case used filler rod 316-L, what happen in the future Their Consequences.
Please let me know its Consequences metallurgy ...
Hope to have news as soon as possible.
Thank you in...
Dear all,
Please give me a suggestion for welding of dissimilar materials Sa 335 Gr P 91( P-No 15 E Group 1) and A 106 Gr B (P-No 1).
What is the correct material to perform welding joint about GTAW (ER) / SMAW (E)?
Thank you very you much in advance.
Best regards.
JM@
Dear all,
Please give me a suggestion for welding of dissimilar materials Sa 335 Gr P 91 and A 106 Gr B.
What is the correct material to perform welding joint about(ER / E)?
Best regards.
Magalhães Julio
Dear expert,
Please I need the help, with the best PWHT for material dissimilar Sa 335 Gr P 91 and Sa 335 Gr P 22.
Because I've of the joint for PWHT, Dia: 12" X 25mm / 28" X 33mm.
Thanking very you much in advance.
Kindest regards.
Magalhães Julio
Dear gentlemen
I need to make a pipe spool with an 24" X 20mm SA-335 GR. P91 and two welding.
I need to know the minimum spacing for the welds, so as to make the spool as small as possible.
Thank you very much for help me again.
I'm apologize for my English is...
Dear experts
Please help my so when you have a short tube for to complete the measure, which the measure is determined by two or three diameters code?
What is the code that determines the mandatory?
Thanking very you much in advance.
Kind regards
