Looking for a bit of help.
Our firm has a section of our machines subbed out to another company. They have a fairly old machine that PLC's battery died and they lost the software.
We've managed to source the software and I was supposed to re-load yesterday. I'm no PLC expert, still learning...
I've been at a breakdown today where a part is spraying water through a calibrated hole which then funnels into a 10mm pipe and via a very intricate measurement unit that is basically 2 x oval cam'd/geared peices in a seat which 1 of the cam's has 2 x magnets which trigger reeds for your PLC...
Hello,
I learned a bit of PLC during my apprenticeship about 10 years ago writing in instruction format in dos on old bosch plcs. Now i'm required to work on mistubishi q-series and fx series on windows and in ladder logic.
I'm fine with the troubleshooting side of it, but editing and...
We've got an issue with one of our leak test sequences in work.
Here's the set up:
Main pressure - regulated - leak tester - leak tight valve (plc operated) - sealed face - welder injection moulded bottle.
After every break or at start up, we get a leak fail. When re-tested, the bottle...
Hello,
I'm new to the forum, so sorry if I've posted this in the wrong section! I'm a mid 20's lad due to oversee some machine re-locations from Central Europe (Czech Republic) to the UK. I'm just wondering a few things.
1) If the 3 phase machine in it's current location is running at a...
