I have a ring shaped straight bevel gear with a regular pattern of threaded holes to mount it. All is needed in order to detail it in drawing, is a longitudinal section and a quarter section (to dimension angular pitch between holes). In my case, half a section would be incorrect (generally in...
figure this out: you trim in several points an axis for a shaft and repent doing it. There is no way to go back. If you erase the axis it gets listed again in the "Show model annotations" tab and you can select it again. But it's still trimmed where you had truncated it. Extending and playing...
Hi everyone!
My current issue with Creo/elements is the following: when I make a local section that is contoured by some edges and a spline, the spline shows with the same width as for geometry (0.5 mm).
This is logic, because it becomes an edge itself, but I'm working in ISO standard and it...
well, I'm facing this issue with Creo/Proe5
the help file says that there is this command:
"create conical surface"
http://www.kxcad.net/proe/restyle/to_create_a_conical_surface.htm
whilst, AS USUAL, I can't find it.
Obviously (note the sarcastic tone) this command was already in ProE w3...
Hi everyone,
I'm training on pro/e wf3.0 and facing a very frustrating problem.
I'm supposed to design a differential gear (classic), so you know there are shafts and spline coupling joints, which are not meant to be sectioned in technical drawing. I know the option "Exclude Component" from the...
