Anybody can help me to figure out Pressure vessel head calculation? I run with ANSYS for pressure 8.25Bar. Head thickness is 7mm , min 8mm -1mm corrosion. But Von-mises stress is 202Mpa that is higher than allowable stress 137Mpa. Can I comparable vonmises stress and allowable stress? So that...
Good Day to you all,,
May I ask some question. I hope anybody can help me here. I confused to calculate Drum torque. Drum weight is 200Ton. Pull force at layer dia 5.6m is 20Ton. As my option, Torque is 20Tonx 2.8m= 549kNm..But I found 607kNm in specification. I can't clarify which one is...
Good Day to you all,,
May I ask some question. I hope anybody can help me here. I confused to calculate Drum torque. Drum weight is 200Ton. Pull force at layer dia 5.6m is 20Ton. As my option, Torque is 20Tonx 2.8m= 549kNm..But I found 607kNm in specification. I can't clarify which one is...
Dear Sir/Madam
I engineering DNV classed offshore container. I calculated floor bending stress and deflection. I calculated floor panel max. deflection from "Roark " formula for stress and strain . Each floor Panel size is 1100mm x 400mm x 6 mm thickness. uniform load assume is 22.32 KN/m^2. How...
Dear All.
Can anybody reply me to know and calculate nominal thickness. I used pressure vessel plate 516 gr.70 minimum thickness is 28..how should be nominal thickness?
Thank in advance
Good day to you all.
I am a new engineer in pressure vessel designing.I working in pressure vessel in human occupancy design company.I would greatly appreciate if anybody help me to get right way. Normally I read design according to 2007 ASME boiler & pressure Vessel code. But for me that code...
