Hello everyone,
I am working within a European Company which manufactures pressure vessels as per European Standards (EN 13445-3). We would like an approval for CRN.
However to my knowledge, not all Provinces accept "design + materials" as per European Standards.
We will follow then the ASME...
Hello everyone,
I am working on wave induced fatigue on a pipe under Caesar II. My loadcases are :
1 (OPE) W+D1+D2+T1+P1+WIN1+WAV1
2 (OPE) W+D1+D2+T1+P1
3 (FAT) L3=L1-L2
I woulk like to know how I can generate on output the force/moment variation on my nodes/elements? I am not sure that...
Hello everyone,
I have two Caesar II input files, the first one is with the correct geometry and the wrong displacements/restraints/wind/current_conditions, while the second one is the opposite (wrong geometry and correct parameter). I would to know how do you import the correct geometry into...
Hello,
Im trying to run a heat transfer analysis on a box in abaqus standard (steady state). A bulkhead is in the middle of the box tied to the two sides.
The BC's are two different temperatures on the different sides of the box.
The analysis stops with a message error: there is more than one...
Hello everyone,
After running an explicite analysis, I wanted the stresses on some elements sets to be written on an ASCI file. I would like to know, please, what do I have to write on the input file so I can generate a .fil ?
Thanks.
Hello everyone,
I am modelling the application of a pressure on a box laying on three wedges. I used contact surface-to-surface between the three wedges and the bottom shell of the box, with some friction(0.2).
unfortunaltely, when I am looking at the energies outputs, the energy due to...
Hello everyone,
I have a contact problem between a rigid and a deformable surface.
I am using a kinematic algorithm, and a surface to surface contact. I am putting a normale pressure on the rigid surface so it can squeeze the deformable one, and it works finely for some steps while the...
Hello everyone,
I am working right now on a plywood box simply supported by wedges under a uniform pressure of 1 MPa.
The pressure is applicated through a rigid shell part layed on the top of the box ( a surface to surface contact). The bottom of the box is on contact (surface to surface)...