Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
AMETANK DESIGN PRESSURE, IN GUAGE OR ABSOLUTE PRESSURE?
Hello Team, Good day to you all. please I will like to find out, if the pressure unit in AMETank Software is in gauge or absolute? This is because I am design a crude oil storage tank and the design pressure is 1psi. But when I input my design pressure of 1psi (6.8kpa) the result I get from...- Omuye
- Thread
- Replies: 10
- Forum: Storage tank engineering
-
Determination of Flange Rating A694 F52 Material
Goodday, please how do i determine the flange rating of a 30" Flange of material A694 F52 (ASME B16.47) Given the design conditions Temp - 38degC Pressure = 1480PSIG. Thanks for your assistance. Regards,- Omuye
- Thread
- Replies: 4
- Forum: Boiler and Pressure Vessel engineering
-
Design of Reinforcement openings.
Dear All, Please i have been studying a book "Guidebook for the design of ASME Section VIII Pressure Vessel" by James R. Farr and Mann H. Jawad. Reference to the attachment Example 5.1. highlighted in yellow for the calculation of reinforcement openings. After the calculation of the minimum...- Omuye
- Thread
- Replies: 3
- Forum: Boiler and Pressure Vessel engineering
