Hi, is anyone familiar with using PD5500 for high cycle fatigue analysis in piping system according to DNV-RP-D101?
I am running various load cases using CAESAR II to identify the different stress ranges in my piping according to the rain flow method as required but:
CAESAR II outputs two...
Hi, I’m looking for some clarification on a point.
I have read around this topic quite extensively and think I have gleaned the knowledge I require but I have not found an explicit answer to my query without getting too bogged down in the theory.
The query is: which stress we should use from...
Hi, I’m looking for some clarification on a point.
I have a query as to which stress we should use from CAESAR “stresses extended” output for our input to DNV/PD5500 high cycle fatigue analysis.
I am not using the CAESAR ASME high cycle fatigue module so the stress values in question are...
Hi,
I am currently struggling with pipe stress and pipe support of some 1" or less pipes and tubes. The lines are hot, some 500c (low allowable stresses), and the wind loads are high. The lines are insulated and traced and the overall diameter of the pipe, tracing, insulation and cladding is...
