Hi everybody,
I'm running a Steady State Thermal Analysis (sol 153) of an assembly using FEMAP and Nastran. My load set comprises a number of heat fluxes, which are supposed to be dissipated by radiation. At the steady state, I expect the summation of heat fluxes (power) to be exactly...
Hi everybody,
I need to simulate - with a satisfactory accuracy - the attachment between a PCB (Printed Circuit Board) and some electronic modules through a pin-in-hole solder connection (see picture attached).
I found plenty of articles about the so-called Global-local modelling technique, in...
Hi everyone!
I'm facing two problems with the Design Optimization tool of Femap 10.2 with NX Nastran, namely:
- when optimizing rods subject to compressive loading (therefore producing negative axial stresses), the solver fails if I set a negative value for the design constraint (for example...
Hi everybody, this is my first thread.
I'm a beginner with Femap and Nastran, therefore there could be some basics I ignore or I'm not familiar with: I would be very grateful if you gave me some general tips, besides the specific issue in subject.
I'm using Femap v.10.2 with NX Nastran to...
