Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Timothi
  • Content: Threads
  • Order by date
  1. Timothi

    Chiller Primary & Secondary Pump Flow Rate

    Experts, I request your valuable comments on the case below, Two numbers of 80 TR (W,S) chillers are installed for a commercial building of 100 TR cooling demand. Chillers are designed considering 20% diversity factor. There is a constant flow primary pump set with water flow rate 200 GPM...
  2. Timothi

    Apparaturs Dew Point Temperature

    Dear Experts, I have the following data for heat load calc using excel sheet. Outside DB = 38 Deg C Outside WB = 30.8 Deg C Outside RH = 60% Inside Room conditions = 23.5 Deg C, 55% RH Room Total sensible heat = 10000 BTU/HR Room Total latent heat = 1800 BTU/HR There is no mixing of return...
  3. Timothi

    Chilled water system PRV set point

    Experts, Can someone list out the steps to find pressure relief valve set value in a closed loop chilled water system? Thanks in Advance Sharing knowledge is the best way to learn
  4. Timothi

    Air cooled chilled water system

    Experts, In a variable primary flow chilled water system (air cooled), total frictional loss is 6.5 bar as per calculation. Is this same as chilled water system working pressure, or different? Thanks in advance Sharing knowledge is the best way to learn
  5. Timothi

    Primary-Secondary chilled water system

    Hi experts, HVAC related books say, in a primary-secondary chilled water system, the flow is controlled by the 2-way valve in the coil return side and the pressure in the supply pipe shoots up which is sensed by the dpt and dpt signals the secondary pump vfd to reduce pump speed. If this is...
  6. Timothi

    Chilled water system -Maximum Design pressure Vs Operating pressure

    Hi experts, In expansion tank sizing software the following inputs required. 1. Maximum design pressure 2. Operating pressure How to calculate these parameters? Thank You Timothi Albani

Part and Inventory Search