I am trying to set up a contact analysis between a lifting pin and the inner surface of the lifting bracket hole, both have different diameters.
When setting up the connection 2 contact areas must be defined. Is this the contact area before material deformation begins? Bearing in mind the...
Hi
Can anybody who is familiar with AutoPipe analysis provide me with some assistance.
When is it appropraite to apply ASME B31.3 appendix P to the pipe stress analysis.
I am finding that I am getting radically different results when the Appendix P option is active.
Corsa 007
Hi
Can anybody who is familiar with AutoPipe analysis provide me with some assistance.
When is it appropraite to apply ASME B31.3 appendix P to the pipe stress analysis.
I am finding that I am getting radically different results when the Appendix P option is active.
Corsa 007
I understand this is a CEASER thread but can anybody who is familiar with AutoPipe analysis provide me with some assistance.
When is it appropraite to apply ASME B31.3 appendix P to the pipe stress analysis.
I am finding that I am getting radically different results when the Appendix P option...
Can anybody who is familiar with AutoPipe analysis provide me with some assistance.
When is it appropraite to apply ASME B31.3 to the pipe stress analysis.
Corsa 007
Can anybody tell me the difference between bolting materials SA-320 B8M and SA-192 B8M.
I am aware that SA-320 is for low temp operation but they both have exactly the same chemical composition and maximum stresses. Why is SA-320 B8m limited to a maximum temperature of 38C. It is difficult to...
