OK, so everything was fine in my assembly until I changed the width of a bracket. Some mates broke due to how the assembly was constrained but when I try to fix them with any sort of assembly constraint my cursor will only highlight a body. I can't grab any features to actually mate. Even worse...
I wasn't sure if this should go here or in other topics but I figure you folks must know something about simulation.
I am interested in utilizing a lap simulation software for my Formula SAE team. The main use this program would see is to justify decisions and give our team direction. For...
So I wasn't sure where to post this. Is there a machining forum? If there is I must have missed it.
Anyway, I've found lots of info on the minimum thickness of a material to be tapped but I haven't found anything regarding how wide the material should be.
In other words, how much material...
OK, I am having a lot of trouble utilizing loops and if statements. I have some experience with programming but for some reason writing these macros is killing me.
I just want to create a macro that will go through every single cell and check it to see if X is in that cell. If X is in the cell...
Hey guys, just joined to try and get to the bottom of this.
Im using Solidworks 2010 student edition. I just recently noticed that when I try to use hole wizard I get some issues. Firstly, I dont get any options for the hole. I can only select "hole type" "standard:" and "type:" are grayed out...
