I have a situation where there is a basement wall 10ft (3000mm) high. on the interior side of the wall approx 900mm behind it, is another wall to support a fireplace (also 10ft high). The small 900mm space between the two walls will be backfilled. While designing the exterior for retaining is...
I have a cutting operation where I had a 14" blade with 80 teeth, spinning a 1800 rpm with 10HP motor. The material being cut was pushed through at 8.3ft/min. We measured the amp load on the motor.
The force required to push the material through was approx 800lbs.
Then we changed the blade to...
I am designing a drive system that carries cement material through cutting heads on a tray and then returns for new material. I have established the gear ratio and motor size.
I need a 10HP motor that is capable of 155rpm to 1800rpm under constant torque. Based on this, I have been told that an...
I am trying to decide which drive to buy and they all seem to be the same. Can someone help me to choose between:
Vacon
Benshaw
Allen Bradley
I have a fairly simple low voltage application and need a drive to run a 5hp motor driving a conveyor back and forth. 1000 cycles per day...need...
Hi I have a question regarding sizing the gear for a specific range of output.
I have an application where I have a carriage bringing material through cutting heads and then returning on a linear actuator. I would like to use an inverter duty motor (say anywhere from .5HP to 2HP). I would like...
