Gentlemen, I need some help with concept feasibility. I am looking for feedback, advise, recommendations, opinions, experiences and thoughts on the bonding aspect of this concept and not other ways to join the parts.
The details are as follows:
7in outside diameter steel power transmission...
Hi guys,
I need some help with my understanding of permanent magnet DC motor operation. I am building a spreadsheet to model motor performance. I'm an ME and my electrical knowledge is poor so I have started with the theoretical side to help develop my understanding. I have a few good books...
All,
I am beginning the design of a drive shaft for a critical application. The shaft will be located in an outside environment and unprotected. It will subjected to bending, torsion and axial loads. Failure of the shaft will result in catastrophic damage.
After doing some reading...
I need help in locating the correct type of seal for my application.
I effectively have two flat faced flanges rotating with respect to one another. I need to place a seal between the flanges somewhere near their od so I can maintain a large area of grease film between the two flanges and...
I need to design a die that will allow me to crush a 3.0in. diameter 0.096in. wall 6.0ft. long DOM tube into an oval ~1.75in. x 3.XXin.
Can someone point me towards something that will teach me how to calculate a close estimate of the stiffness of a cylindrical tube perpendicular to it's axis...
I am having problems.
Is there any way to unfold a solid part with radiused corners or insert bends on radiused corners?
Due to part geometry I cannot create edges, insert bends and then specify the radius.\
Chris S
