I've held out upgrading to Solid Edge ST (v100) until three weeks ago. I am a long time Solidedge use since v11. I'm still using "traditional" modeling so no problem there, but am struggling with the using the new Ribbon (MS Office 2007) interface. I use a 3-button mouse and otherhand on...
Hi All,
This post started in thread1103-221577 (Drafting) and as requested I want to continue it here.
I have put in an IR to GTAC, but have not received an answer yet.
To Recap my Problem:
My company historically uses Multiple Assembly Parts Lists on our drawings. For example, an assembly...
My company historically uses Multiple Assembly Parts Lists on our drawings. For example, an assembly has two variants that are the same except for the Battery Pack (lithium or alkaline) and Circuit Board (Lithium or alkaline). In the drawing Parts List we will have a "-1" and "-2" "QTY REQD"...
I'm ordering a new workstation for SE + Internet, etc. with a price limit of $3000. Research has led me to the Dell T5400 with following setup:
Quad Core Xeon E5405 (2.00GHz)
4GB (4 DIMMS)
nVidia Quadro FX1700
no monitor, no mouse, ...
Dell Storage options I'm considering now:
1)two 73GB SAS...
My basic problem is to ruggedize (ie. shock mount) a heat-generating device (35 Watts) inside a sealed enclosure.
I am considering using thermal gap pad material (Chomerics or 3M), but it is still very stiff...does anyone have experience using this material? are there alternative materials/ideas...
I'm designing an underwater heatsink that needs to dissipate 90W. The basic problem is a horizontal cylinder 4.5 inches Dia X 6.0 inches Long, and sits in salt water at 70 deg F under free convection only. I've found the inside temp. results to be highly dependent on the free convection (film)...
