Hi,
I want to know the allowable bearing stress for glass at location of bolt.
The location is the splice location for the glass fin which has bolted connection arrangement.
ASTM E1300 specified edge stresses for different types of glass in (TABLE X9.1 Allowable Edge Stress).
Can these values...
thread507-242316
Dear Experts,
Could someone shed light on the matter that the time period to be sent for wind tunnel should be based on uncracked (SLS) structural frequency or based on cracked section (ULS) to determine the Wind forces.
If it should be uncracked (SLS), is there any reference...
I am designing de-silting chamber. There are two divide walls in the chamber, making three bays, independent of each other. I want to evaluate the factor of safety against sliding for the chamber. The critical case is the tank full of water and earthquake. The question is that, to determine the...
Hi all,
I am working on the structural design of a concrete gravity dam. The spillway is 56 meters wide. Three radial gates openings (12m wide x 15m high) are made for the spillway water leaving behind 6.4 meter thick piers. Contraction joints are placed in each pier for the entire 55m height of...
Hello!
I am trying to determine the pore pressure distribution within a slope resulting from a rapid drawdown of a lake, using ABAQUS. I am specifying the initial condition of pore pressure, void ratio and saturation. For the transient analysis I am specifying the pore pressure boundary...
