Hi,
Is galvanizing full length of anchor bolts necessary for galvanized bolts or galvanizing the protruded portion only will suffice.
Any guidance is appreciated.
Regards,
Tabby
Hi All,
I was searching ASME Section VIII Div 1 for a provision that MAWP can be taken as Design Pressure i.e
MAWP = Design Pressure
Even if MAWP is calculated during design calculations (Obviously its value is higher than DP). However, I coudn't find one. So, I thought someone here could...
Hello Everyone,
I was modeling on AutoPIPE when I came across mill tolerance.
According to my understanding, Mill Tolerance is the tolerance for variation in the thickness of pipe from nominal pipe thickness which is 12.5% according to B31.3. i.e for NPS 10" and thickness 6.35 mm it is 0.794...
Hi All,
Would any of you be kind enough to confirm me the following.
If material of the pipe is A358 TP 321 Class 2 EFW
A358 Specifications Quote
"1.3.2 Class 2—Pipe shall be double welded by processes
employing filler metal in all passes. No radiography is required."
Then
For Piping...
Dear All,
Can anyone guide me to some reference (books, web, etc) where I can find the negative effects of Frequent Start-up/Shutdown on Equipments Used in Fertilizer Industry such as pressure vessels, heat exchangers, piping, valves, compressors, pumps, turbine, etc? Please.
Regards,
Tabby
Hello everyone,
I was trying to perform a finite element analysis of a heat exchanger expansion joint on ANSYS following RCB 8 of TEMA. I modeled it according to Figure RCB 8.42, applied boundary conditions as per RCB 8.41 and determined spring rate. Now to determine deflection to be applied...
