Hey guys I have been working on a nose cone and I found these nice formulas for nose cone designs in Wikipedia which is a real convenience for quick modeling.
http://en.wikipedia.org/wiki/Nose_cone_design
Now, the usual way I would design it would be to use Excel to get general values and...
I am curious about what exactly the limits of Flow Simulation are for SolidWorks. I was working on a thesis (completed and cleared) which was to analyze a scramjet isolator scaled up for 10 and 100 times the cross section. The initial CFD analysis was to simulate M=1.8 airflow entering from a...
I need some help figuring out a technical issue. The point of this exercise is to organize dimensions in a staircase fashion (cascade) so I can fit the dimensions in the drawing without going beyond the borders of the drawing sheet. I have shortened the line pointing to the number for the...
I'm trying to continue a previous thread discussing standards for military work.
thread1103-193705
I'm part of a small company that is doing defense contracting work, as part of my job, I was researching how drafting standards have changed, since I was learning engineering drafting in college...
I found this thread closed and was trying to understand proper standards with regard to ASME Y14.5.
thread1103-200390
The previous thread mentioned proper labeling with regard to screwholes. However, I am currently at a phase where we have not determined the type of screws we are using and...
