Sketch is fully closed, drawn on a plane. Curve is projected onto a curved and flat part of the structure. As it is projected the rear line (left hand side) which closes the box dissapears. I draw one in on the projected curve, and select it during the extrusion process, but still continues to...
Sweeping along an arc. Two different cross sections. I know this has something to do with the vector alignment of the initial sketch, but don't remember how to correct this problem. Any help is appreciated. Not supposed to fold in onto itself like that.
Hello, I recently installed NX on my machine, and i notice the letters and icons are a bit "fuzzy" but what is worse, The image tends to dissapear partially, as if passing through a plane which hides the image. This happens with a sketch or 3d model.
I remember this happened a few years ago at...
Hello, as a final school project i would like to design a system that uses both constant variable valve timing along with constantly variable intake. This would be for a race engine setup. Basically telescoping intake runners, that are synced to the cam variation as well. Change in both is based...
I'm designing an intake for a single cyl 450 cc kawasaki motor. Need some clarification of the placement of certain areas of the intake pipe. What I'm thinking is run a bellmouth intake ontop of throttle body, tapers down to class mandated restrictor, peice of straight pipe (1.5" diameter-same...
Hello, first time posting in these forums, hopefully you kind folk can point me in the right direction.
We are running a 550 cc aprilia vtwin engine for FSAE. We are required to run a 20 mm restrictor, in the order of
Throttle body - restrictor - [blower - intercooler] - plenum.
Now from my...
