Hello,
Could somebody advice me at the following question:
Quote:
Acc.to Table 4.2,note D) CJP groove weld qualification on any thickness or diameter shall qualify any size of fillet or PJP groove weld for any thickness or diameter
Question: Would a CJP Groove weld Qualify a Multi layer and...
Hello,
We are currently planning to make new fillet weld qualfications acc.to figure 4.19. Are there leg lengths mentioned at the weld size table to the plate thickness T1 and T2 or throat thickness?
Thx in advance
Chris
Hello,
Our company have 2 more site companies, belong to API Q1 managemant system
Our welding standard is AWS D1.1
Are we allowed to share the qualfied PQR and WPS between the companies
Thanks!
HAllo,
I have an X-Joint welding 2G top and welding 4G up.Because we will not turn the plate. This is covered by 2 different welding procedures.One procedure covers the 2G with testing acc to clause 4, the other procedure covers 4G.
Is it allowed to cover one joint by 2 different procedures at...
We have qualfified SAW welding 2G acc to joint B-U5B (Clause 4), however, joint B-U5B is not for SAW. I Know that SAW is in general not Qualified on SAW.
Can somebody advice me?
Greatfull thanks!
I have to weld 6gr wpqr test. Acc. to fig 4.27 AWS D1.1.
Outer diameter is the same, but the wall thickness is minimum 5 mm les on the 37.5 degree side.
What wall thickness value i have to count with acc. to table 4.6.
Pipe is Job Size test pipe <24" pipe 1: T=<3/4 Pipe 2:>T>3/4
What is the...
Hello,
Can somebody tell me what wall thickness is qualfied for a 6gr pipe with CVN test requirements. eigther the smaller or the biggest on the tube.
P.J.P and Fillet welds.
Thanks al lot for using this great forum. We are in the Netherlands not so familair with the AWS code regulations
Chris
