Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: brice14
  • Content: Threads
  • Order by date
  1. brice14

    Well drilling woes

    I have a well driller who drilled a well for me that went down 270 meters and "didn't find any water". However, as I listened above the hole, it sounded like running water. So, I lowered a HD camera into the hole. As can be seen on the video http://www.youtube.com/watch?v=6K6BQ6cZwE8 there is...
  2. brice14

    Pumping into the distribution lines

    I'm building a system for about 10 homes. I would like to pump into the distribution system to avoid running/maintaining two tubes to the reservoir. I would like to turn on/off the pump with a standard pressure switch and a nearby pneumatic tank to avoid running wires to the reservoir. At...
  3. brice14

    "high" pressure water pump

    I feel silly asking this question, but I've searched high and low on the internet and can't find a pump solution for my needs. The requirement is 500 ft of head (including losses) at 6 gallons per minute flow rate. I have 240 volt service available. Most "deep well" pumps seem to tap out at...
  4. brice14

    Long (300m) run impedance transformation

    thread240-218990 This question was asked and answered on the referenced thread. However, this engineering newbie didn't quite understand. I have a relay whose signal switch is about 300m from the relay. A tester (DC) "sees" the circuit as open, but the relay (240 AC) "sees" the circuit as...

Part and Inventory Search