Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Dual Dimension Appearance
I'm a newbie to SolidWorks and I have a question on how to set up the dual dimensioning in the drawing. Can you change how the dual dimension appears in SW2006? From what I see, it puts the secondary dimension on the top in paranthesis. Can these paranthesis be turned off? Can you you change...- ahbugeye
- Thread
- Replies: 3
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Radial Generated Dimensions
I was wondering if anyone else had figured out how to change the generated dimensions of diameters to show only a partial line. Say I have a Shaft and I only want to show half of the section view through the shaft. Since the sketch is set up with diameters, the generated dimensions are...- ahbugeye
- Thread
- Replies: 0
- Forum: DASSAULT: CATIA products
-
Clamp Load
The bolt is 25mm and the two different hole sizes are 26 and 32mm. Would the clamp force or load be different in the larger hole? I expect the resultant stresses to be higher due to less contact area, but does this also effect clamp load? Thanks for your help!- ahbugeye
- Thread
- Replies: 2
- Forum: Welding, Bonding & Fastener engineering
