Dear Gentlemen,
A friend of mine asked to perform a few calculations in order to find out if the threads of a Nut and Screw could sustain the amount of traction force applied.
So, I performed the calculation to find out the area of the threads in contact and, using a factor of 2, I have found...
Dear All,
Here at company we have to install an axle onto two (3) bearings. After using Lame´s equation I was able to find the pressure generated due to the interference between the outer diameter of the axle(wich is solid) and the inner diameter of the bearings.
My question is regarding the...
Hello Gentlemen,
I was designated to create a tool for our maintenance depot and since I am new in the company I would like to show a good work by providing all necessary calculations and so on.
Basically we have a pinion with 65 mm OD (+0,024,+0,011 tolerances)that fits by interference in the...
Gentlemen,
I am trying to assembly one camshaft using SolidWorks and everything was going fine until now. The problem is that I need to add an angle between the cams and I am not beeing able to do it. Right now they are both aligned. I can rotate one of them manually but this is not a good...
