Hi guys,
I'm having a machine that is sort of like a cam following mechanism, which is more of copying the circumference of a mold, and spring is used to control the extending and retracting action.
The fact is i'm really not familiar with pneumatic components, i tried to use an air regulator...
Hi Guys,
I'm a total newbie to machine design and i've been reading and researching about bearings fitting and mounting methods and which i came up with this design i have as a cam follower block.
I'm confused if this is the right way for the bearing assembly as well as, will the bearing 6205...
Hi,
I'm actually have zero knowledge in motors. But, I'm wondering is it possible to configure/set up a three phase motor to having 2 different speed? I'm trying to make a machine for shear forming that require 2 different speed for roughing and finishing.
Best regards,
Picks
Hi guys,
I'm facing a big problem which i've never come across or expected. Hope that could get some FAQs and advise.
I'm having a batch of faucet(with nuts together as an assembly)rusted when put in water. Tested for around 2 hours and rust could be seen on nuts and threaded area of faucet...
hi!
i am currently working on an air tight compartment by using 2mm thk mild steel. Say i have 5 pieces of 2mm mild steel being cut to size to build up the perimeter and base of the box, anyone have any ideas on how to join them together into a seamless air tight box??
been checking out on...
