Hi,
Not done this sort of things since college days.
Some input would be much appreciated.
Please refer to the attached .pdf. The diagram is a schematic drawing only.
In order to determine the weld size, I need to calculate the force (N) at the diameter of the welds (888mm).
The inner flange...
I am trying to find a formula to determine the time required to build pressure in a cylinder.
ie. how much time would it take build pressure of 6000 psi in a cylinder by 'dead ending' it.
Please forgive my ignorance in advance, I am not a software engineer
so here goes.
We have a version of an old basic program written in the 1980's.
We believe it is compiled.
We are looking to have it re-written.
Is this possible?
I am looking to design a system to test the wear characteristics between components A & B.
I require the cylinder to apply a pressure of 0 to 6000 psi in 1 second then return to start position in 1 second, ie 2 second cycle time. The intention is to run the test for 76,000 cycles. The clearance...
I require to produce 8:ff slits, 0.2mm wide X 165mm long in the wall of a tube which is 56mm o/d X 50.8 i/d. I have enquired about laser and water jet cutting and been informed that these are not suitable for this application. Wire erosion is a possibility. Any ideas?
