i am starting a new house project and would like some advise with regards to the design of a concrete beam.Tthe detail for the Reinforced concrete beam which sits above the garage is described below:
Beam size: 12" wide x 20" Depth
Top Reinforcement: 6x5/8" Rebar at 1/3 span to the ends of the...
can someone provide advice about this service?
i am having frequent seal failures with large amounts of coke buildup in all areas of a double seal. the plans are plans 41/52. coke was found in the primary and the backup seal bellows,faces, pumping ring, gland ports etc.
the product is cooled...
Does anyone have experience with this service?
Water is injected into the heater tubes to increase turbulence and minimize coke lay down. Currently, we are using some milroyal B packed plunger pump. The flowrate is 59 GPH at 505 psig max. We are experiencing very poor reliability. I would like...
I am considering the use of a vertical cantilever recessed impeller pump for a sump application. The pump product has sand, silt, vegetation, BS&W and some amount of sticky oily sludge. what are your experiences with recessed impeller pumps? do you think this is a suitable application?
