Hi,
Hope somebody can help me with this:
We are planning to fire test our product (a pipe connector) according to API 6FB.
Our product will be tested under part II (offshore well bay conditions.)
After reviewing this test specification, it is not clear to me if bending is a requirement or...
Hi,
Hope somebody can help me with this.
What safety factors are most common for hydraulic cylinders? Especially for Europe, so refference to an EN standard would be great.
So far I have just found the following factors to use:
Pressure test at 1,5 times rated pressure (ISO 10100)
Yield...
thread725-287736
Ref. earlier discussed question:
Can A333 always be used to replace A106?
I have almost the same question:
Does steel A333 Grade 6 always satisfy the requirements for A106 Grade B?
We do all testing for our products on A106 Grade B pipes and with this assume that results...
Hi,
I am looking for the low temp elongation properties for Titanium (Grade 2 - unalloyed - "comercially pure")
In room temp the mimimum elongation value is 20% (for seamless pipe according to ASME B861), but how does it change at lower temperatures?
Anybody konws? Hope somebody can help me...
Hi,
Are there anybody out there who knows the technical definition of this term?
"gasket seating surface" (gray region marked in Fig D-2 in attachment)
It appears from the figure to be about half of the raised face area, but I cannot find anything written in PCC-1 to back up that assumption...
Hi,
I want to use a standard hose clamp (attached example) for a subsea application. (Permanent installation, about 20 years life time).
Problem is, the only corrosion resistant steel I can find for hose clamps is AISI 316. I would prefer to use a higher quality steel, like 6Mo, AL-6XN or...
Hi,
I am trying to find out a bit about the history of DIN flange standards. When was the latest revision issued? The latest I have found is March 1975... Is there no later issue?
When was it withdrawn? Did ISO 7005 replace it in 1992? And then EN 1092 in 2001?
The withdrawn DIN standards are...
