Hello all,
i have used a mesh for a computation that is finish. Now, i want to import the variable PEEQ on a new mesh but i don't understand how i can do this,
can you help me ?
To have stress initial condition it is easy : *initial condition,type=stress,file=oldODB
but for PEEQ i don't...
Hi all,
i am not sure that have been well understood the abaqus's help :
1- it is not possible to used the command "map solution" with dynamics analysis ?
2- we can just import in a new mesh the stresses and no more things ?
thanks for your help/confirmation
Hi all,
i have an easy question. With abaqus i mesh a part with several kind of elements.
=> but, can i write all informations of these elements in the INP file ?
for example i have a big part and i want to know for all elements :
1°) its index (easy : it's already in the inp)
2°) its volume...
hello world !
i have an abaqus model with a mesh and material properties.
do you know how i can get the stiffness matrix? with report? how?
thank you for your help :-)
Hello world,
i am a beginner and i test to do a easy model on abaqus.
I want to simulate the transient temperature field for a cube which have this dimensions:
1x1x1meter and this characteristic:
-> conductivity: 3.7e-8 ohm.m
-> density: 2700 kg/m3
-> specific heat: 896 J/(Kg.K)
The problem...
Hello all,
I have two small questions about Abaqus, I hope you can enlighten me.
It's been a while since I work on Abaqus and there are two things that I never understood / used:
1) when I do meshes I always meshes independent, what does it change for the calculation if i use dependant?
2)...
Hello world,
i have a job with a subroutine, when i run the job abaqus say:
"Error in job AAA: Problem during compilation - ifort.exe not found in PATH."
i have search in this forum and i find this solution:
"Assuming you have administrator rights:
My...
hello world!
i want to model a laser beam on abaqus which it move along a plate.
do you know how i can to that?
thank you in advance (i think i have to use the command dflux?)
Hello,
i have seen in the abaqus's help that we can use CGAX6 and CGAX8R elements, but i don't know how to use this elements:
this elements are for the axisymetric modelisation with rotation out of plane but when i try to mesh with the CAE i don't find this elements.
==> where are this...
Hello,
i try to do a torsional test on abaqus in a cylinder.
I block the lower surface and i put a rotation of 0.5rad on the upper surface, but the result isn't conform:
==> the V.M. stress are null
Can you help me please? How put a rotation on my test tube
in attachment you can find my model
Hello, (I am french, so sorry for my bad english)
I do a subspace steady state analysis, in entry of my system i take a Serie of Fourier to Impose a periodic displacement of nodes (the fundamental is 1Hz).
In my subspace steady state analysis i create 10frequencies for the response (1Hz to...
