Dear friends,
I am working on the Well Integrity Management Program for SAGD wells. Can anyone suggests where I can find information on [highlight #FCE94F]corrosion of saltwater disposal wells? including casings and downhole tube[/highlight]
Appreciated
Hello All;
A pressure vessel was constructed with SA 516 Gr.70 has undergone PWHT initially in 1975.
How many times the vessel could undergo repair & PWHT in its lifetime? Are there any maximum times can anyone do PWHT?
Will metallurgical changes occur during subsequent PWHT?
Where I can find...
Hello All;
We had an average size of repair completed on an internal attachment to shell of a pressure vessel. The defect area was ground smoothly and filled with proper weld procedure.
Subsequently, the area was examined by 100% MPI. No defects were found. Hydro test was not done due to...
Hello everyone,
Vertical plates which supports downwards trend of the flow in digester (pulp and paper making) has been bulged. Those bulges are quite large. The plates made of 304L SS. The temperature in this area falls between 300 - 320 F. Can anyone tell me what was cause for bulging to...
Hello everyone,
I need to weld channels which hold the plate as shown in the picture to the Chiller support. The welding method is SMAW using 7018 rod. My concern, will there any damage to the CuNi 90/10 cooling tubes adjacent to welding of these channels?
Appreciate for early response.
Demsha
Hi All;
In some columns of my house the contractor has not cut off the excess reinforcement steel bars. They are sticking out of the column. I presume they will get rusted over time. My worry is; Could that rust penetrate inside the concrete? What should I do to prevent it from going inside? My...
Hello All,
Can any tell me, what type of damage mechanism could exits in Glycol heat exchanger?
shell side: either heated or ambient temp. Glycol
Tube side: Produced water, Blowdown water or Hydrocarbon (C7)
Thanks in advance
Dear All,
Does anyone knows where I can find (literature, journals etc.)possible corrosion rates in refinery equipment? At this tiime I am looking for corrosion rates in Distillate Hydrotreating Unit
Thanks
Hi All,
can someone tell me, how to estimate corrosion rate from process sampling and operating variables in refinery equipment?
Gas absorber and Amine regenerator in amine unit and reactor vessel in Hydrotreating unit?
Thanks in advance
Hi all,
Which one of stainless steel is more prone to carburization Austenitic or Ferritic?
Adding Aluminum will increase the carburization resistance?
Thanks in advance
All,
does anyone knows least amount of volatile organic compound exist in which coating technology below
Nickel plating
Magnesium flame spray
Chromium carbide HVOF (high velocity Oxy fuel) technology
I want to know correct procedure usually applies in automotive industry.
Thanks
Hello All,
Our client is connecting two screw piles by welding a collar (sleeve) into it. However they were doing this welding when outside temperature was around -30 0C below.
After our repeated screaming, contractor began to weld in a covered tent. Can anyone tell me where I can find answers...
Hello All,
I need to calculate output current of Mg anode which protects the pipeline.
I know the area of the anode. Where can I find current density for Mg (magnesium) to soil? (we know the soil resistivity)
Thanks for your help
To All;
Does anyone knows reasonable interval between calibrations of a torque wrench in a construction site? Some company specifications call for calibration twice a day which is impossible.
Thanks in advance
