Some may recall a technology known as DF Steer, somewhat inverse of ADF (Automatic Direction Finding). Logically, DF Steer Equipment has been mothballed, but finding it is another matter. Optionally, finding the DF Steer engineer garu, or manufacture would be helpful.
The application is near...
The device BOM will include two of our proprietary 8 Embit rolling custom code 802.15.4 transceivers. One transceiver will be attached to the mobile target, the other will be located at the antenna. Range between the two will be from antenna base to 200 feet LOS. The antenna will then pan/tilt...
The basic spec. needed is a cross to the Bourns PRM162 series, motor driven ptentiometer. The model is available from Mouser and Digi-Key. However, not in needed ohm values.
The two ohm values needed are 500K and 10K.
RF is the primary control W/user friendly, manual control available. The...
We need help finding an assembly solution. The RF module includes a Uart. The present design is REV 4A, hardware, REV 32, C code.
The RX side is found to perform. The TX side is a different part number and has a 20% failure ratio. The Board assembly has been attempted in house and by 4 seperate...
The burglars got our SMT, Proto-vision PIP w/remote microscope, Good SMT soldering equipment, bins,tweezers, flux etc. Maybe someone knows of GOOD equipment laying around or suggestions on to-days new package deals.
What is the present supplier of choice, PlC or Bus. Programming to be in C++ or Ladder logic. Quadrature encoder capable, on board 120/240 VAC - 50/60 Hz, dual high speed counters, relay or solid state, small to medium capacity.
Application:Offshore race/pleasure boat,BBC,800-1300HP @6-7000 RPM,engines are well built w/details available.
Problem:As these engines are used for pleasure, 92-93 octane is used. Due to lack of preferred inner cooler design,no inner cooler is used and engines are over engineered in other areas...
