Hello,
I am attempting to mate a fairing part to a sweep (my cable). The path of the sweep is a spline to simulate the free movement of the cable. I am having a difficult time getting the two to mate properly. Any suggestions? Thanks for the help.
I am need of a ceramic material that can be used to pot or encapsulate integrated circuits. The material will be used in a seawater environment, exposed to high pressures, and is submersed in a mineral oil reservoir. I would like the ceramic to be room temperature curing, and ideally one...
I am trying to find an "off the self" very low pressure piston for a ID: 3.095" cylinder, I am looking for a piston that can easily slide back and forth similar to the part used in a noise making "gravity tube" like this
(http://www.amazon.com/Toysmith-TRANSLUCENT-GRAVITY-TUBE/dp/B000YIJWWA) or...
I am working on part names for a new line of products we are developing. Does anyone know where to find the standards or rule of thumb convention for doing so? Is this regulated or accepted by ASME or another organization where I could find standardized information? Thanks for any input you can...
I am trying to find 316 stainless steel heat staking plastic inserts. Most companies offer 300 stainless steel inserts, but I am looking for 316. Does anyone know of a company that can make, or stocks, such plastic inserts? Thanks
I am designing a pressure vessel for an submarine. Does anyone have any experience or suggestions with these alloys for this application?
Aluminum 5086 H111
Aluminum 5454 H111
Aluminum 5456 H111
Thanks
I am designing a pressure vessel for an submarine. I does anyone have any experience or suggestions with these alloys for this application?
Aluminum 5086 H111
Aluminum 5454 H111
Aluminum 5456 H111
Thanks
I am trying to use electronic epoxy potting material in a two part mold. I am having problems finding a material that will act as a seal and not stick to the epoxy along the seam. Does anyone have any experience doing anything like this? I am currently testing a silicone rubber mold any...
Hello,
I need to simulate a load on a small 2Hp electric motor we are using. Does anyone have any suggestions from previous experience? Are there any companies that make test equipment for this?
I had several ideas...
1) Drive a generator and applying a known electrical load to it.
2) Using...
I have been trying to find general angle tolerances to put into drawing title blocks but cant find any. What are general tolerances for angular tolerances of machined and bent angles? Can anyone help with what a standardized value for these would be?
