I have an open top hydraulic wood grinder that utilizes a ram to push the material through cutting teeth.
The grinder is located approximately 5' below the floor level of the plant on the outside of the building.
Three of its sides are protected by brick walls and therefore have no access.
The...
I am looking to install a semi-down draft dry spray booth to spray UV coatings within.
The questions I have are:
Is the UV coatings, like the ones typically used on wood furniture, greater than an ignitability flash point less than 140 degrees F.
Are the dry filters, which are expected to...
I am looking to install a semi-down draft dry spray booth to spray UV coatings within.
The questions I have are:
Is the UV coatings, like the ones typically used on wood furniture, greater than an ignitability flash point less than 140 degrees F.
Are the dry filters, which are expected to...
I need to find an efficient way to neutralize UV coating material in water?
I am spraying a water based UV coating on wood products in a "side down draft spray booth" and I would like to be able to break the material down after it is sprayed onto the product and the overflow gets...
I need to find a listing of all the symbols that I can use to represent flow on a plant layout AutoCAD drawing.
e.g.- I have a product family that flows throw a department and then splits off in to several directions to go to different work cells.
What symbol represents that split (one input...
If I were to spray a glue mixture onto a flat surface at a controlled and constant rate of flow, with a constant mixture viscosity, and the shape that is formed from the spraying forms a circle how can I approach solving for the amount of material that I have applied at t=1 sec, t=2 sec, t=X...
on my drawing in AutoCAD R14.
I have even completed a block transfer of another drawing from our network to utilize their formated size, but as soon as it is imported over and I attempt to explode the drawing it changes to the unwanted default size of 0.18 text height.
A little assistance here...
I am joining two tile-rails, 2 cap ends and 1 brace-cross to one another. Currently, I am using a Toggle-Lock system which requires 10 BTM presses 5-10 tons each. The space that the presses take up is huge. I am looking for a replacement to the system that is on a smaller level that I can...
Can anyone weigh in on the Advantages/ Disadvantages for using either flying laser or fying plasma technology in an in-line process.
Also, if you have had a particular good experience with a supplier or integrator of either technology could you provide a reference.
Thanks in advance.
I have a roll formed process in which 16 gauge HRS, with Rockwell B 60-70 is pulled through series of roll formers and flying dies. The part is formed into a square and needs to be supported from within to prevent deformation if punched after forming. There are two in-line locations in which I...
I am attempting to design a combo weld fixture that will allow for the welding of two steel blocks to each end of a steel bar by two operators.
I am thinking of a barrel enclosed in a triangular support fixture. This barrel will allow for the loading of the 1st end blocks and the steel bar...
I am interested in purchasing a vacuum lift with a jib for under $10k. It will need to lift steel sheets weighing approximately 100 lbs and it will need to have the ability to rotate on all axis. Is this a possibility or do I need to fork over more?
