Hi Everybody,
Can you guys point me to some good resources on the net for tolerance stack analysis. Also are there any good books available for the same.
Greatly appreciate all answers. Thanks to everyone who answers in advance!
Thank you,
Siva
I have this part which has two planes offset from each other.
1. can I call one plane A, and another Plane B, and call Primary as A-B
2. If i do the above How do I tolerance those two planes relative to each other? Should i call out a profile tolerance relative to A-B?
3. Where would the...
Hi All,
I have this plastic part that is warped in free state. But it works well in the assembly which is all I want. What is the best way to call out a note in the drawing saying that the part is to be measured with the datums constrained. I looked up some notes and one says
"NOTES (UNLESS...
Hi Everyone,
My questions pertain to the attached figure.
-I have a sheetmetal part.
-I have a face that goes against another part, and so am using that plane as Datum A. This face constrains Translation in Z, and rotation about X and Y.
-I have six staggered dog-bone type feature (see...
