Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Arrow tail length in Drafting
NX 9.0 Any way to adjust the length of the arrow "tail" in Drafting? I've looked in the usual settings (both for the dim itself, and in Drafting Preferences) and can't see where that length is controlled. As shown in the example, all I want to do is shorten it by a smidgen so it doesn't run into...- icconian
- Thread
- Replies: 6
- Forum: Siemens: UG/NX
-
Drafting: Smash View - any pitfalls or tips?
I have an I-DEAS drawing that has been read into NX 9.0 for revision. It is all 2D - a piping schematic. Although the text can be edited, the curves cannot. The lines can't be moved, length changed, etc., nada. I've discovered, however, that "Smash View" can be applied to this original view...- icconian
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
-
Synchronous Modeling linear dimension
When you apply a linear dimension using Synchronous Modeling, should it appear on the screen after you hit OK? Mine show up in the Part Navigator, but not on the screen view of the part itself. I can click on the listing and get to edit, but can't normally see what the linear dim is applied to...- icconian
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
