Guys!
Just trying to figure out about the vibration on one of the installation onboard.
the alligment between motor and pump, pump and pipes is ok.
the foundation is up to standard. all stiffners are in order. Still, i have quite significant vibration.
i haven't open up th e pump yet to...
Gents!
Need some advise on the tolerance between rubber expansion bellow and pipes.
The alignment on the pump discharge is ok but the alignment on pipe side read 4mm diferences.
so, the question is, how much allowable tolerance for the said bellow with pipe, and what standard which i could...
Assuming I have a pump which supplied water to PHE (cold-side) at 50m3/hr.
what happen if the supply of water is decrease since i'm want to tap that line for other services?
I'm doing a project wich required me to calculate the transfer rate of Barite & Cement from tanks to tanks. I've run couple of calculation but i'm not sure it is the correct one or not.
the detail is as follow;
Pipe size = 5" / lenght of pipe (approx. 100 ft)
eductor = 1" c/w fluffer vlv
acfm...
