I am proposing a design for galvanizing where a 1/8" thick 3" box section is welded to the side of a 3/8" thick 4" box section - where one wall of the 3" box is inline with the side of the 4" box - ie. it is off centre by 1/2". The 3" box cantilevers out from the 4" box and is unsupported at...
This is a debate I have had at few companies I've worked.
On assembly drawings - on the bill of materials list - should one include revision level.
I believe - no. Revision level is a property of the part and should not be on the assembly drawing. It would mean that even the slightest change...
I use Wildfire with the model window full screen. Recently, during component assembly, when I go to spin my model my "Component Placement" window gets covered by the model window. So, I must then shrink my model window to pick the edge of the "component placement" to get it back on top.
Used...
