Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: xrmntech
  • Content: Threads
  • Order by date
  1. xrmntech

    EG/Water mix (75% Ethylene glycol and 25% Water)

    Thanks very much in advance for your assistance. Need to find a pump for application below. Suction pressure= -2 psig (see note below). Suction Temp= 175°F Discharge Pressure= 1200 psig Flow= 15 gpm Fluid= EG/Water mix (75% Ethylene glycol and 25% Water). Viscosity= 1.5 cP Note: Pump takes...
  2. xrmntech

    Vertical Turbine Pump: Balancing correction vs Components wear out

    Is balancing correction an acceptable practice to extend motor-pump service life when upper vibration increase is caused by down pump components wear? On our vertical turbine pumps (Filtered water @ 80°F, 15 stages, 3600 rpm, 1000 HP, 30000 BPD, TDH= 1500 psi) we check motor uncoupled...
  3. xrmntech

    Face to Face spacing between 6"-600# flanges

    I'd appreciate assistance where in the codes I can find a table with recommended spacing (gap or distance) between flanges faces. The particular application I have this time is for a 6"-600# flange connection using 2Xflexitallic gaskets and an orifice plate (0.130" thickness). Temperature is...

Part and Inventory Search

Back
Top Bottom