Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Standard tolerancing on stainless keys and keyways
Hello all, I am looking for some feedback regarding a request from a supplier. One from our supplier is requesting that shaft keys and keyways be toleranced on our prints in such a way that the keyways would *always* be bigger than the keys. For instance, if standard tolerancing on stainless...- CristianF
- Thread
- Replies: 30
- Forum: Mechanical engineering general discussion
-
If part changes rev is the assemblies change rev as well???
Hello all, I’ve been looking all over the forum regarding this question and probably I wasn’t looking hard enough, because I couldn’t find a satisfactory answer. To give you some background… There is no MRP or PDM system in place. The files are saved with a different revision at the end (123R1...- CristianF
- Thread
- Replies: 8
- Forum: Engineering project management general discussion
