Hi all,
With reference to thread292-267966, what would you answer to the following question :
For a set-in 12" nozzle made of welded pipe TP304L Sch80S, that does not have circumferential butt welds in its assembly, Category C fillet welds [such as shown in Fig. 2-4, sketch (3a)] are used to...
Hi everyone,
After reading through ASME VIII div 1, some of its code cases, ASME V, and various papers about the subject, I am trying to make up my mind about the most convenient way to inspect the welds connecting set-in nozzles to their duplex vessel.
I would usually stick to the code...
Hi everyone,
Since 2008, ASMEVIIIdiv1 requires that "test pressure and coincident static head acting during the test" is considered in designing a vessel.
I hope I was not the only one to keep an eye on this before code eventually asked for it.
However, div1 does not mention specific acceptance...
I have a question regarding ASMEVIII Div1 UG-42
When two similar nozzles are installed on a longitudinal line of a vessel, and both nozzles are radial, I have no problem using UG-42 since whatever the plane I consider, the finished diameter d of the opening (as defined in UG-37) is the same...
