Hi, I have a issue about a reinforcement design, acording to ASME B31.8. And is on point 831.41 General REquirements... specifically on section "e" "The area of reinforcement ...is defined as a rectangle whose length shall extend a distance, d, on each side of the transverse centerline of the...
Hello.. I'm doing a WPS and when try to define point QW-406, I got freezed, because I was trying to find some information about how determining interpass temperature when welding low carbon steel pipes (ASTM A106B). I read something in asme Section IX and AWS D1.1 but it is not so clear...
I have to make an O-ring, but I'm using a Buna-N cord (widht 1/2 IN). The question is... How can i joint both ends?. I know I need a glue but which one can I use? and what are my options?
Thanks
Alejandro Fernández
I+D&I
Sitelca
Hi there... Can anyone know something about sch for api 10000 rating in pipes and olet like weldolet and also the wide dimention for 2 in weldolet (same rating)?
I Was looking in MSS SP 97, ASME B16.11, some catalogs, and found noting about it..
Alejandro Fernández
I+D&I
Sitelca
Can anybody know the circle diameter & bolt diameter of stopple plug? This is used to attach the plug holder to stopple plug, in order to install it. Flange dimention: 8 & 12 IN
I read a lot of catalog, books, patents and talked to many people about it and get no information..
PS: Attached to...
