Hi,
i have an imported 3d meshed model from ansys icem cfd. I need to create a cylinder model over this mesh model so that the cylinder touches in exactly with the mesh model circumferential. The problem in here is , as there were no entities(like area ,volume, lines) imported from icem cfd to...
Hi,
I have exported an icem cfd mesh to ansys with ansys as an output solver. The problem lies with the node numbers when i see the mesh in ansys icem cfd it has less node numbers that that in the ansys classic. The node numbers are missing (i.e 1,2,3,5,6,8.. where 4 and 7 nodes are...
Greeting
I have carried out some electromagnetic analysis in a different software with the mesh obtained from ansys icem cfd and tried using this same mesh and heat flux data obtained. But the heat flux input data contains some nodes which are not there while meshing the model in icem cfd...
Greetings,
I amtrying to read an text file in ansys whcih consists of x,y,z coordinates some arbitary load i have gone for. My input code is as follows
...
*dim,trial,table,96,96,6,y,x,z
*tread,trial,tyxz,txt,,0
...
i even tried %tyxz% in place of tyxz..
Error is " Tread cannot open...
Greetings,
I was trying to run ANSYS in the batch mode. Can somebody let me know whether i can get the reult plots in the ansys batch mode? I tried using the plesol,plnsol etc. but i couln't get any plot from the ouput.
Thanks in advance
Greetings,
Is there a specific command to select the nodes on only the surface in the batch mode? Can we list these nodes? I am working on a 3-d model.
Thanks in advance
