I am trying to understand the amplification factor(Ap). Sorry for being all over the place with this post but this is my first time using these equations. Also I will have a P.E look it over I am just trying to get a feel for it.
I have a column with a mass at the top with a fundamental...
I have an arm assembly that is made out of two square tubes. One is smaller than the other and extends in and out of the larger one. Their are small tabs welded to the walls of the tubes that prevent them from sliding completely out. The arm is loaded with a point load at the end of the...
Can the pins in pulleys/sheaves be modeled as fixed-fixed?...if so, what standards must be followed for hole sizing? Is their a standard to follow?
I have always modeled them as pinned-pinned(symply supported), but I was asked this question and not sure about it.
I also found this info on...
Anybody out there know how to calculate the forces on brake caliper brackets? Or know where I can get info on this...
Sorry for my crude post....this is my first one.
