Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Lcubed
  • Content: Threads
  • Order by date
  1. Lcubed

    Electromagnetic coil

    I am a retired Aerospace Structural Engineer with only rudimentary knowledge of Electricity. I need a cylindrical, hollow-core coil which will lift a 30-pound slug vertically into its hollow core when energized. The slug is steel and is about 2 inches in diameter. The energising voltage is...
  2. Lcubed

    Limitation on Use of von Mises

    Hi All, I understand the principles behind the von Mises Yield Criterion, and I think I know when it should and should not be used, but I have seen it mis-used on several occasions, and I'm doing further research. Most references state that it is used to find Yield and, as Corypad pointed out...
  3. Lcubed

    Carburizing Stainless Steel

    Hi All, Can SS be carburized? I have a shaft with a spline on it which is carburized to Rc 58 or so. Is it possible that this shaft is made of stainless? Thanks and regards.
  4. Lcubed

    Properties after Heat Treatment; wall thicknesses

    Hi all, Reference page 2-18 in MIL-5H and MMPDS, Table 2.3.1.0(c2. Properties for MIL-T-6736 in the first two columns are different, but the wall thkns is the same; is this a typo? Also the third column has higher properties for 'all walls'. I am a stress analyst and not a metallurgist...
  5. Lcubed

    Moving spreadsheets with $

    Can anyone tell me how to copy a spreadsheet containing cell designations such as $a$1, to a new location without dragging those cell designations along? Say, for example, I want to copy the sheet to a new location 12 lines down, and I want cell $a$1 to become cell $a$12, in which I will put...
  6. Lcubed

    flow through an oil filter

    Hi All, Could anyone tell me the direction and (ball park) rate of flow through an automotive oil filter? Thank you.
  7. Lcubed

    Simple? Statics

    A load is imposed at the center of a square 4-bolt pattern. One bolt is removed. How is the load distributed to the remaining 3 bolts? I know the location of the "new" centroid of the fastener pattern, and I have calculated the moments about that point and the resulting reactions. I have...

Part and Inventory Search

Back
Top