Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: JB23
  • Content: Threads
  • Order by date
  1. JB23

    Does anyone know of source to obtai

    Does anyone know of source to obtain a cast iron ASME pressure vessel? The design and manufacture of the vessel would be the responsibility of the supplier - similar to a fabricated vessel.
  2. JB23

    What stress values (safety factors)

    What stress value (safety factor)is the required reinforcement area based on? My objective is to determine the safety factor when the actual area is less than the required area. Thanks for your help.
  3. JB23

    Does anyone has a definition of wha

    Does anyone has a definition of what makes a pressure container an integral part of a rotating mechanical device? If you encapsulate a rotating mechanical device is the container automatically excluded from code requirements?
  4. JB23

    Cast Iron Allowable Stress

    Are the cast iron allowable stress factors - 10 for tensile, 6.67 for bending and 5 for compression - set to minimize permanent distortion? The factors for cast iron are considerably greater than those for steel (3.5 currently).
  5. JB23

    Hydrostatic Testing

    What is the purpose of a hydrostatic test conducted at 1.3 to 2.0 times the maximum allowable working pressure? Is this primarily a leak test? Does this pressure validate the structure integrity of the component? Your opinions, comments and intrpretations are most welcome.
  6. JB23

    Hydrostatic Testing

    What is the purpose of a hydrostatic test conducted at 1.3 to 2.0 times the maximum allowable working pressure? Is this primarily a leak test? Does this pressure validate the structure integrity of the component? Your opinions, comments and intrpretations are most welcome.
  7. JB23

    What are some suggestions to elimat

    What are some suggestions to elimate wear on a pump shaft and drive utilizing a flat shaft and slot?
  8. JB23

    Swing Check Valve

    We are investigating the use of a swing check valve to control reverse flow at an air compressor inlet. A swing check valve was chosen to minimize flow restriction. I am under the impression that swing check valves offer the least resistance due to the straight flow path. I am concerned that...
  9. JB23

    Swing Check Valve

    We are investigating the use of a swing check valve to control reverse flow at an air compressor inlet. A swing check valve was chosen to minimize flow restriction. I am under the impression that swing check valves offer the least resistance due to the straight flow path. I am concerned that...
  10. JB23

    swing check valve force

    how do you determine the fuild force on a swing check valve plate for sizing of an acutator? are there any informative sites available? Thanks for the help.

Part and Inventory Search

Back
Top