When calculating a RSS is there a minimum number of tolerances than can be used? I have seen RSS results with 2 tolerances(the very minimum) used for the calculation and have been told that an RSS should not be used unless there are 5 or more tolerances used in the calculation. Nobody where I...
Hello All,
I am trying to enforce a small displacement on a thin cantilever beam in the horizontal direction, then apply another displacement in the vertical direction.
I was trying using subcases but the subcase manager only allows loads to be managed and not displacements. How can I apply...
Sometimes when I want to move a component in an assembly the option "By Constraints"
is not available. It is grayed out. How/why does this happen?
L. Jones
NX 7.5.4.4
TC 2007.2.2.3
I have a 4017 counter triggered by a 555 timer using an 6 volt Vcc. When the counter goes through the ten step sequence the output through each outlet is 6V at 3mA. I would like to step this output up to 150mA to drive a 6V coil relay.
What is a recommended way to step up the output? I would...
