Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. DiplingAndre

    ASME SA-928?

    Dear Guys, I'm looking for the ASME SA-928. Could it be, that the ASTM A928 is not transferred into the ASME SA-928 standard? I have only the 2008 version of the ASME IIA at the moment but there is no ASME SA-928. Could someone tell me if its included in the latest version or not? Thanks a lot!
  2. DiplingAndre

    ASME IX QW407.4

    Dear all, I have a question regarding ASME IX (2010) QW 407.4. "QW-407.4 For ferrous base metals other than P-No. 7, P-No. 8, and P-No. 45, when a procedure qualification test coupon receives a postweId heat treatment exceeding the upper transformation temperature or a solution heat treatment...
  3. DiplingAndre

    X-Ray API 5LC

    Hey Guys I have a question about the acceptance limits according API 5LC. For example for round indications there is a table with columnes size Adjacent size Minimum Separation Maximum Number in any 6 in/152,4 mm first row is size: 3,2 mm adjacent size: 3,2 mm Minimum Separation 50,8 mm...
  4. DiplingAndre

    Hydrostatic pressure Test for pipes

    Hi Everyone, I have a question. Is there anywhere a clear definitaion what a hydrostatic pressure test is? I mean the pressure test of a single pipe (by the manufacturer) not a complete system. Is the test a leak test, where you pressurize to the test pressure, stop pumping and see if the pipe...
  5. DiplingAndre

    Formula for guided bend test Jig-diameter API %LC

    Hello, I've some problems withe the calculation Fig. 4 in API 5LC The Formula is A = (1,15(D-2t)/(e-D/t-2e-1))-t D is for example 16" or 406,4 mm t = 0,204" or 5,2 mm e = 0,1025" or 102,5 mm I think that the formula is not correct coz i found in an old version (1991) A =...
  6. DiplingAndre

    Max. Hardness Duplex Nace

    Can anyone tell me what is the max. hardness for duplex ss acc. Nace MR0175 and where i find it? I just found a value of 25 HRC for HIP but I need it for cast steel.
  7. DiplingAndre

    Where to find SA

    Hello, can anyone tell me where I can find the material specification AMSE SA 312 and SA 358. I have the ASTM A 312 and 358 here but I'm not sure if there are some additional Requirements or something like that.

Part and Inventory Search