I've recently come across a Flow measurement application that seems suited to using a Venturi tube as the primary element (I need low DP and now sharp edges), I've used a lot of Square edged plates in the past but have never specified a venturi I have the proper software to do the calculations...
I am trying to choose a pump for the following conditions:
Flow: 2-10 gpm
Discharge Pressure: 1000 PSI
Suction Pressure: 20 PSI
Fluid: Low Viscosity (1 cp) organic
I'm assuming that it is a job for a PD pump but I'm not sure which style. We use PD pumps elsewhere in the plant but they are all...
We have a MEA stripping column in our CO2 removal unit with an extremely undersized kettle reboiler, a problem that should be fixed in our next turnaround but that is 18 months away and we are looking for ways to get enough heat into the column to operate at reasonable rates until then.
One...
I support a syngas plant that uses the sulfinol process to remove CO2 (and very small amounts of H2S) from the syngas stream. I am in the process of designing an improvemnt to the plant that will allow us to increase syngas production by about 10% but the sulfinol unit is already at full...
