Hello
I have to do stress analysis of cross country (Fuel gas) piping. Though I had done the stress analysis for in plant piping,this is new for me. Are there any special considerations which I must take care? I am going to do the analysis in Caesar.
Thanks all.
Hi Experts
I have a pressure vessel made of stainless steel designed for vacuum (design temperature 200 deg.C). I need to have stiffeners; according to design carbon steel stiffener is sufficient. From the point of view of welding, is it advisable to use only stainless steel stiffener?
(I have...
Is there any limitation on the maximum l/d ratio that can be used for a hozl. vessel?
I want to use only two saddle supports.
thanks for your help
N.SEKAR
Hi all
DOes ASME SecVIII has anything to say about the L/D Ratio to be used for a vertical vessel? I am designing a continuous blow down tank in a boiler system.I am just wondering if there is any guideline to find out the optimum L/D Ratio
thanks for your time and help
Hello
We are designing a piping system for the Heavy water Upgrading plant for one of the existing Nuclear Power Plant of 220 Mwe PHWR.
Can any one of you suggest what special precautions apply?
Thanks for sharing your experience.
REGARDS
hI
I am designing a exhaust steam duct at the back of steam turbine connecting the aircooled condenser. I have to select proper expansion bellows (metallic) and calculate the anchor forces and order the right expansion bellows. Any references on how to do this? I am using Caesar-II pipe stress...
