I am working on a linkage system that has a relatively large amount of misalignment during operation due to thermals.
I am planning to use a spline shaft in this linkage system. Does anyone know how much misalignment involute crowned splines can withstand (I'm sure there are variables that...
Hello,
I am looking for some statistical methods that may be applicable to a study that I am performing. I am currently performing some vibratory high cycle fatigue (HCF) testing on some parts in a 1F mode. I need to demonstrate that the parts have a certain amount of HCF strength, for...
Hello,
I am looking for some statistical methods that may be applicable to a study that I am performing. I am currently performing some vibratory high cycle fatigue (HCF) testing on some parts in a 1F mode. I need to demonstrate that the parts have a certain amount of HCF strength, for...
I have imported volumes into ANSYS and meshed these with tets and bricks. I currently have the ability to select volumes and then subsequently select elements or nodes that are attached to these volumes. I thought that since the volumes are made up of areas, I could select an area and then...
